'*READ FULL ARTICLE WITH PHOTOS* https://muscularstrength.com/article/Seven-Dumbest-Barbell-Bent-Over-Row-Mistakes The barbell bent-over row, one of the few exercise that can either build MASSIVE MUSCLE or waste a lot of your time. Like anything else in life, if anything is worth doing it needs to be done right and this exercise is no exception. Some even consider the barbell bent-over row to be the barbell bench press for your back and for the sake of this article we are going to be discussing the OVERHAND-GRIP version of this exercise. The difference between overhand-grip and underhand-grip is that the overhand-grip is going to primarily target your UPPER BACK muscles while underhand-grip targets more lats / lower back and traps. So this means that if done properly you should feel this movement throughout your traps, rhomboids and even your rear delts. You will activate your lats as well, but they will not be the primary focus in this movement. In fact, you should be using the overhand-grip barbell row with the goal of working more of your mid and lower traps because these are areas that do not get targeted a lot. Also, because the barbell bent-over row strengthens the upper back it’s basically counterbalancing what the bench press does for your chest and shoulders and it will ensure good posture while providing a subtle lower-body and core workout as well. This is because you have to stabilize the weight by engaging your core and activating your glutes, quads, hamstrings and calves to stand in place and perform the movement. Now below are the 7 dumbest mistakes gym goers make when performing this movement and after you finish reading, your back workouts will never be the same! MISTAKE #1: Keeping Your Legs Straight During The Lift When performing the barbell bent-over row you MUST have a bend in your knees. Bending your knees will allow you to push your hips BACK so you have a solid base to hold you in place to lift the maximum amount of weight. If you perform this movement with your legs straight you will place a great deal of the load on your lower back which can cause spinal flexion and in time a lower back injury. You will also be placing yourself in a very awkward position which will greatly hinder the amount of weight you will be able to pull off the floor. MISTAKE #2: Not Bending Over Enough During The Movement The more “bent-over” you are, the more range of motion you’ll create during the movement which means more “time-under tension” for your back muscles. Remember, to build muscle you need to first break it down and there’s a HUGE difference between having your upper body parallel to the ground versus standing up and barely bending over. When parallel, the barbell has a much greater distance to travel in order to reach your torso to complete one repetition. This means you have to do more work to move the weight. Remember this movement is called the BENT-OVER row. So BEND OVER and do it right! The more upright you are the easier the exercise becomes and you can handle more weight, but the load transfers to more upper traps. Mid and lower traps are usually neglected by most people so why avoid it here? Stay as parallel as possible so you can work on building bigger mid & lower traps as this is what the exercise is intended for. MISTAKE #3: Standing Up During Your Reps As mentioned previously, in order to get the most out of the barbell bent-over row your upper body needs to be completely parallel to the floor. What happens to a lot of lifters is that as soon as their muscles start to fatigue they instinctively begin to stand up taller and taller. Like we just discussed, standing tall makes the exercise easier to lift more weight and some of you may be doing this without even realizing it. So the next time you train your back, really pay attention to ensure you’re not standing up as your muscles begin to fatigue. If they do, lower the weight. MISTAKE #4: Keeping Too Much Tension In Your Neck & Spine One of the worst things you can do during this movement is place too much tension in your neck / spine. In fact, when doing any exercise you want to keep your neck and spine as neutral as possible to avoid any kind of excess tension which can cause a strain in the muscles in the area or even worse, a tension headache. *CONTINUE READING HERE* https://muscularstrength.com/article/Seven-Dumbest-Barbell-Bent-Over-Row-Mistakes Program Selector - Get The Right Program For You! - https://muscularstrength.com/Program-Selector ---------------------------------------- Subscribe To My Channel - https://www.youtube.com/user/ScottHermanFitness ---------------------------------------- 1 on 1 Online Coaching - http://muscularstrength.com/consultations ---------------------------------------- DOWNLOAD MY APP! – iPhone & Android! https://muscularstrength.com/phoneapp ---------------------------------------- MORE TIPS! - https://www.instagram.com/ScottHermanFitness'
Tags: Workout , exercise , muscle , Weight Training (Hobby) , Physical Fitness (Industry) , Scott Herman , back , traps , lats , Fitness (Magazine) , Bent-over Row
See also:
comments